Ok , install is done. I will test it next week. Removal of the 1st back plate assembly took me a long time, the other 3 were not bad at all. So figure a 3 to 4 hour job by yourself. Half that if you have help and all the correct tools. It took me a while to determine what wrentch i could fit that gave me the most force to remove the bolts without rocking the TT off the jacks.
On another note, i think i set them up correctly, the wheel spins but just barely hit the pads. I will adjust my controller when i have time to test it out. This is correct right? I didnt have to ajust them at all, but maybe they were sent out pre ajusted? The new hubs were pre lubed, so berrings in place, with seals and races. Just take off the vover and plop them on.